Thermal, Ridge, and Wave

Thermals
Thermals with cloud bases of around 10,000' enable gliders with modest performance to cross the Columbia River canyon to the mountains west, to safely reach the spectacular destinations such as Glacier Peak or Mt. Stuart .

The two favorite routes both start from the ridge east of Pangborn either taking the "south route" crossing the Columbia a mile or two north of the Rock Island Dam, proceeding via Jumpoff Ridge to Mission Ridge, and then heading directly over Blewet Pass to the higher peaks. Or taking the "northern route" crossing the Columbia at the Rocky Reach Dam, continuing to Burch Mountain, and bumping thermals on to Icicle Ridge west of Leavenworth, and on to the higher peaks.

Of course, the most reliable thermal soaring area is to the east of Wenatchee all the way to Idaho. Thermals become very consistent and predictable usually after the first ten miles east of the Columbia River. For the first "badge" cross-country flight in thermals only often the "Pangborn - Waterville - Mansfield and Return" task is chosen.

On most Saturdays and Sundays April through September, listen on 123.3 to pilots launching mostly out of Ephrata. Often it is possible to team up with them when they are in the Wenatchee area and fly along with them.

Ridge

Ridge lift is plentiful in the Wenatchee area.  The escarpments surrounding the Columbia River canyon form fantastic ridges with basalt lava columns rising hundreds of feet vertically, a spectacular sight when soaring along these ridges. The most popular ridge towards which most tows go are to the north and east of the airport, roughly two thousand feet above the airport elevation. The ridge rises gradually to the north from its low point of 2,800' MSL (about three miles east of the airport) to its high point near the summit of Badger mountain at about 4,200', along a winding path about 20 mile long. This ridge "works" with a remarkable range of wind directions, starting counterclockwise from 330° along its northern portion, from 300° to 200° along most of its length, and in its most southern section even with southeast winds up to 120°. On strong windy days the effect of the ridge extends well over 1,500' above the ridge.

There are other many great ridges in the area, the one deserving special attention as a stepping ladder towards Mission Ridge is the Jumpoff Ridge. One can slope soar it to its dead end where it meets at the right angle with the main Mission Ridge . There one has to transition by means of thermals above the main ridge (if the winds are westerly). With northerly winds one can continue without help from thermals from the dead end of Jumpoff on to the bowl of the Mission Ski Area, and have a blast ridge soaring there.

Another great ridge is the one extending northwest from the top of Burch Mountain. One can follow it in westerly winds to just east of Lake Wenatchee where transitioning into thermals and climbing up is recommended in order to maintain sufficient glide to known safe landing spots, such as the Lake Wenatchee airport.

Thermal-Ridge

This specifically local phenomenon deserves a special chapter. It enables soaring at Wenatchee on stable and calm days, when no one elsewhere manages to "stay up". The basalt lava columns rising hundreds of feet vertically along the top of the eastern ridge face south and west, accumulating the sun rays and storing the heat. Eventually the temperature rises in them so high that thermals are triggered along a continuous path right above the lava columns. This lift can be used for a final glide when the day is "dying", or just for having fun when no one else can stay up.

What you want to know about the Wenatchee Wave


Disclaimer: this information has not been confirmed recently. Pilots are responsible for making sure they have current information!

For the skilled and prepared soaring pilot, wave lift provides the means for incredible altitude gains (the record stands at 50,671 feet); far above those attainable in a typical piston-powered aircraft... and well above the altitudes allowed for Visual Flight Rules! Fortunately there is a legal way for soaring pilots to access these heights.

Letter of Agreement


The 
 and the 
, in cooperation with the Seattle ARTCC, have established several glider wave window areas in Washington State. A copy of the Letter Of Agreement with ARTCC may be found here (PDF format, revised in 2003).  A map of the various wave windows may be found here (PDF format, revised in 2009).  

To operate under this agreement you must be a member of the Seattle Glider Council or the Columbia Basin Soaring Association. Alternatively, SGC or CBSA may, at their discretion, allow you to file a signed statement with them establishing that you 
accept and will comply with all conditions of the Letter of Agreement.

Preparations

How can I prepare? It is highly recommended that a pilot wishing to fly in the wave attend a High Altitude Chamber Class to - under very carefully controlled conditions - experience the effect of being at high altitude without supplemental oxygen, briefly experience hypoxia, his/her own reactions to it, and learns the techniques of how to manage breathing at high altitude. Pilots must be
competent in the use of supplemental oxygen equipment, which must be in good working order. A pulse oximeter can be used to confirm that blood-oxygen saturation level is being maintained within a safe range.

Some important information to have on hand:

  • SEA ARTCC 126.1 
  • SEATTLE FLIGHT WATCH 122.0 or 122.3
  • MOS (253)351-3523
  • EAT CTAF 123.0, (EAT)122.6, EAT AWOS 135.075
  • EPH CTAF 122.8
  • EAT ALTITUDE 1245 ft MSL
  • EPH ALTITUDE 1272 ft MSL

Where is it? 

Wave occurs in the Wenatchee area quite frequently, often directly over the airport. The best locations where you are likely to find it are 9 miles southwest of Pangborn airport and/or 10 miles north-northwest of the airport (over the Jumpoff Ridge and Rocky Reach Dam respectively). Due to many ridges in the area you can find waves elsewhere and not always in the same locations, which makes wave soaring around here very interesting and never boring.
 

How can I get that Diamond? 

Unlike in other parts of the U.S. where one has to tow high to get into the wave, at Wenatchee you can get your diamond right off the local ridge! Plus it is safer for you won't have to climb that high for your 5 kilometer gain. A good tactic is to descend as low as you can to sustain in ridge lift to notch the barograph (to descend below 3,000' MSL is relatively easy along the ridge east of Pangborn). When you then add the required 16,400' (=5,000 meters), you don't even need to get above 20,000'. The Diamond is yours! Of course, you have to find the wave once you climb up from the ridge, usually using thermals that drift you downwind. In a series of upwind dashes, each time ending up higher, eventually you connect. Once the altimeter starts spinning, it's the time for oxygen and the clearance into Class A airspace.

What is the Process for Opening a Wave Window?

Notification

The agreement "requires" that the Military Operations Specialist (MOS) at the Seattle Center be "notified" at least one hour prior to any "request" for usage of the Wave Window to allow the area to be cleared of normal aircraft use. The ATC Sector Controller may entertain this initial response on frequency at his discretion, but we should plan to make the initial call by telephone whenever possible. Phone # is (253)351-3523. This advance warning to ATC should be done if the day looks good or, if the day is changeable, when requested by an airborne pilot. Notification should only be made when there is a strong likelihood that wave exists and the window can be reached. Do not make the starting time any earlier than we expect to use it. The Sector Controller may advise that only a partial opening will be permitted or that they will not issue a clearance.

Request for Clearance

A request for clearance by the first pilot at approximately 17,500' will effectively open the window for the rest of us. That call is made to the Seattle Center on 126.1 MHz. However, every pilot/sailplane wishing to fly above FL 180 must obtain clearance from the Controller.

Clearance

The Controller will most likely issue a clearance in response to your request. You and all other sailplanes subsequently operating in the "Window" are then subject to the terms of the Letter of Agreement, as amended, and the flight clearance. This may include altitude and time limits. After passing through 18,000', note altimeter setting, then change to 29.92 inches. Advise Center when transferring back and forth from 123.3 MHz. All pilots must advise Center as they leave the window. (Change altimeter back to original setting.) At least one sailplane should remain on the Center frequency, if possible, and advise Center when the last sailplane has left the window, so the airspace can be returned to normal usage. This call must be confirmed to Center by telephone as soon as possible afterwards that all pilots are out of the window, as they keep a tally count.

Where are the Wenatchee Wave Windows? 

In the immediate Wenatchee area there are two nearby windows, AREA TWO ("Wenatchee Wave Window") and the newer AREA FOUR ("Ellensburg Wave Window").  

Further away are AREA 3A and 3B ("Rattlesnake Hills Wave Window") and the AREA ONE ("Mt. Rainier Wave Window").

Wenatchee Wave Window

ATC refers to this as AREA TWO; it includes altitudes from 18,000' to 23,000'. Contact ATC on 126.1 MHz. It is a rectangle defined by the coordinates:
  • 47°39'N 120°30'W to 119°20'W
  • 47°12'N 120°30'W to 119°20'W
The boundary corresponds with the following geographical locations:
  • The western boundary runs 1 mile west of Cashmere Airport
  • NW corner: 10 miles north of Cashmere Airport
  • The northern boundary runs directly over Waterville airport
  • NE corner: 2 miles northwest of the west end of Coulee City Dam
  • The eastern boundary runs roughly from that Dam to Grant County airport
  • SE corner: Directly over the west end of Grant county airport
  • The southern boundary runs 1 mile south of Quincy airport
  • SW corner: 7 miles southwest from the top of Mission Ridge ski area
Ellensburg Wave Window

ATC refers to this as AREA FOUR; it includes altitudes from 18,000' to 45,000'. Contact ATC on 126.1 MHz. This window is a polygon defined by the coordinates:

  • 47°17'N 120°53'W 
  • 47°18.5'N 120°26'W 
  • 47°13.6'N 119°58'W 
  • 47°01'N 119°58'W 
  • 47°06'N 120°27'W 
  • 47°12'N 120°53'W 
Note: Wave Area Four is sandwiched between Sea-Tac arrival and departure routes and as such has no tolerance for gliders to wander even a mile outside the defined area. Visual references are not sufficiently defined for navigation and only the use of GPS is accurate enough, therefore, a GPS unit is required equipment within the area boundaries defined to enter the area.

Rattlesnake Hills Wave Window

The Rattlesnake Hills region has two wave windows. ATC refers to these as AREA 3A and AREA 3B; they include altitudes from 18,000' to 45,000'.  These windows are south of the new Ellensburg window and defined as follows:

Coordinates AREA 3A (contact ATC on 132.6 MHz):
  • 46°40'N 119°50'W 
  • 46°40'N 119°43'W 
  • 46°26'N 119°26'W 
  • 46°21'N 119°26'W 
  • 46°21'N 119°55'W 
  • 46°24'N 120°00'W 
  • 46°30'N 119°50'W 

Coordinates AREA 3B (contact ATC on 132.5 MHz)
  • 46°40'N 119°53'W 
  • 46°40'N 119°50'W 
  • 46°30'N 119°50'W 
  • 46°30'N 120°00'W 
  • 46°33'N 119°58'W 
Note: AREA 3B is restricted when Yakima firing range is in use.

Mt. Rainier Wave Window

ATC refers to this as AREA ONE; in includes altitudes from 18,000' to 45,000'. Contact ATC on 126.6 MHz. The Mt. Rainier wave window is defined as follows:

  • 47°00'N 121°55'W 
  • 47°00'N 121°34'W 
  • 46°43'N 120°57'W 
  • 46°39'N 121°36'W 
  • 46°43'N 121°58'W 
  • 46°43'N 121°51'W